Operating Functions - Stiga T 102 Série Manuel D'utilisation

Fuel indicator light with level
indicator (Fig. 16.D).
The indicator light shows the fuel level in the
tank in accordance with the following criteria:
Fuel level is between full
and about half full.
Fuel level is between half full and reserve.
Fuel level is in reserve.
NOTE The reserve tank holds
approximately 2 litres of fuel, which is
sufficient for operating the machine for 30-
40 minutes at nominal engine speed.
Flashing indicator light: engine
lubrication faults (Fig. 16.E). Stop
engine immediately, check oil level and
contact an Authorized Service Centre.
Indicator light ON: Grass catcher or rear
discharge guard missing (Fig. 16F) (only
for models with rear grass catcher);
Indicator light ON: when the engine
is running there are battery re-
charging faults (Fig. 16.G).
Flashing indicator light before start-
up: the battery is unable to start
the engine. Contact an Authorized
Service Centre (Fig. 16.G).
Indicator light ON: transmission
in "neutral" (Fig. 16.H).

• Operating functions

Press the "MODE" button to access
operating functions in sequence.
Hour meter (Fig. 16.I). Indicates the total
number of engine operating hours.
Voltmeter (Fig. 16.O). Indicates
the battery charge state.
Tachometer (Fig. 16.K) Indicates the
engine speed as numerical values o r a
series of asterisks, corresponding to:
Displayed values:
< 1600
< 2500
> 2500
*
(**)
**
***
****
*****
******
NOTE When the engine speed display is
flashing, it indicates that the current engine
speed is unsuitable for mowing grass.
Clock (if present) (Fig. 16.L) Indicates
the time in 24 hour/day mode.
To set-up the clock, turn the ignition key
to the «ON» position and, without starting
the engine, proceed as follows:
• Press the "MODE" key repeatedly
until the clock icon appears.
• Hold the "MODE" button pressed until
the first two digits (hour) flash.
• Press one of the two side buttons
(Fig. 16.K, L) to increase or decrease
the setting by one unit.
• Press the "MODE" button until the
other two digits (minutes) flash.
• Press one of the two side buttons to increase
or decrease the setting by one unit.
• Press the "MODE" button to
complete the setting.
NOTE The clock is powered by a back-
up battery; when this battery goes flat,
contact an Authorised Service Centre.
• Acoustic signals - Buzzer
There are two types of acoustic signal:
1. Continuous
acoustic signal:
EN - 14
engine idling speed
transfer speed
cutting speed
engine idling speed
transfer speed
cutting speed
• Electronic card protection
system has intervened.
• The engine has been
switched off for more than
30 seconds with the key
in the "DRIVE" position.