Setting Into Operation - IMG STAGELINE TXS-891HSE Mode D'emploi

5 Setting into Operation

1) Connect a headband microphone or a tie clip
microphone (e . g . the headband microphone
HSE-110 or the tie clip microphone ECM-402L)
to the mini XLR jack (3) .
2) To switch on the transmitter, set the sliding
switch (2) to ON .
The LED status indication (4) shows green
to indicate normal operation . If it shows red
after switch ing on or during operation, the
inserted batteries are almost discharged and
must be replaced .
3) Adjust the transmission channel: By means of
the small adjusting key supplied, turn the ro-
tary switch CHANNEL (5) in such a way that the
arrow points to the desired channel .
The 16 transmission channels are assigned
to the following transmission frequencies:
Channel Frequency
1 863 .125 MHz
2 863 .250 MHz
3 863 .375 MHz
4 863 .500 MHz
5 863 .625 MHz
6 863 .750 MHz
7 863 .875 MHz
8 864 .000 MHz
Note: If other wireless transmission systems are
operated with this wireless system at the same
time, the radio frequencies of the individual systems
should be carefully matched to each other to prevent
interference .
4) Switch on the receiver and set it to the same
channel see operating instructions of the
☞
receiver .
Switch on the audio unit (mixer or ampli-
fier) connected to the receiver .
5) Speak / sing into the microphone . The level of
the audio signal transmitted is indicated on
the receiver .
All rights reserved by MONACOR
reproduced in any form or by any means for any commercial use.
Channel Frequency
9 864 .125 MHz
10 864 .250 MHz
11 864 .375 MHz
12 864 .500 MHz
13 864 .625 MHz
14 864 .750 MHz
15 864 .875 MHz
16 865 .000 MHz
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may be
®
The volume level can be readjusted by
changing the sensitivity via the gain control (6) .
For turning the control use the supplied adjust-
ing key . Adjust the transmitter to the optimum
level . If the level is too high, the transmitter will
distort, then turn back the control (if necessary,
turn it to the left stop) . If the level is too low, a
poor signal-noise ratio will result, then advance
the control correspondingly .
6) After all adjustments have been made, put the
transmitter into the girdle bag again and secure
it with the velcro fastener against slipping out .
7) Fix the girdle bag with the velcro clip on its rear
side to your clothes .
8) To switch off the transmitter after operation,
set the sliding switch (2) to OFF .
6 Specifications
Type of unit: � � � � � � � � PLL multifrequency pocket
Radio frequency
range: � � � � � � � � � � � � � 863 – 865 MHz, divided into
Audio frequency range: 40 – 18 000 Hz
Frequency stability: � � � ±0�005 %
Transmitting power: � � � 10 mW (EIRP)
Ambient temperature: � 0 – 40 °C
Power supply: � � � � � � � two 1�5 V batteries
Operating time: � � � � � � > 30 h
Dimensions (w/o bag): 68 × 195 × 25 mm (W × H × D)
Weight: � � � � � � � � � � � � 130 g
Microphone connection: mini XLR, 3 poles
1 = ground
2 = audio input
1 3
3 = operating voltage 5 V
2
for the microphone
Subject to technical modification .
transmitter
16 channels ( ☞ table)
of size AA (R6)
7