Work Stage - Cola SABINA Manuel D'installation, D'utilisation Et D'entretien

The stove carries out the startup stages in sequence according to the procedures defined by the parameters that
manage levels and times, reaching the work condition unless anomalies or alarms occur, according to the following
table:
Status Duration
OFF
START – CLEANING
PREHEAT
PELLET PREFILL
WAITING FLAME
PELLET LOAD
FIRE PRESENT
WORK
MODULATES WORK
BRAZIER CLEANING
WORK
Pr39 (*)
FINAL CLEANING
After a certain time has elapsed, if the fume temperature has not reached the minimum permissible value the stove
goes in alarm status.
- Do not use flammable liquids to light the stove.
- In case of persistent failed lighting, contact the Service Centre.

4.4 Work stage

After the 'STARTUP' stage, the stove goes to the 'WORK' mode which represents the normal operation mode.
The user can adjust the heat output from the max. value of 5 to a min. of 1 with the buttons 'P5' and 'P6'.
Room temperature
Clock
Dialogue box
Igniter
exhaust
- OFF
Pr33 OFF
Pr34 ON
Pr40 ON
Pr41 ON
- ON
Pr02 OFF
- OFF
- OFF
Pr12 OFF
- OFF
OFF
Clock
Dialogue box
Output
Button 'P4'
Devices
Fume
Auger Exch.
OFF OFF OFF
ON OFF OFF
ON OFF OFF
ON ON OFF
ON OFF OFF
ON ON OFF
ON ON ON
ON ON ON
ON ON ON
ON ON ON
ON ON ON
ON OFF -
Room temperature
Output set to 4
46
Conditions for going to next status
ON/OFF
After time Pr33
After timePr34
After time Pr40
After timePr41
Fume temperature > Pr13
After time Pr02
Room temperature < SET temperature
Fume temperature < Pr14
Room temperature < SET temperature
Fume temperature < Pr14
Every Pr03
ON/OFF to switch off
(*) Pr39 starts from when fume T< Pr13
Button 'P6'
Button 'P5'
SABINA