Spypoint S-WiFi Manuel D'utilisation page 6

10
PHOTO
To take pictures. The «Photo» mode must be selected by
pressing «OK»; the test light in the front of the camera (see
below) will fl ash for 60 seconds
without being photographed.
screen during boot time.
Test light
VIDEO
To take videos. The «Video» mode must be selected by
pressing «OK»; the test light in the front of the camera (see
above) will fl ash for 60 seconds to allow the operator
area without being videoed.
screen during boot time.
SETTINGS
Sets the advanced options of the camera
(see «Settings Menu» for details).
TEST
Allows the user to test the detection system of the camera.
When the «Test» mode is selected, no photo or video
is recorded. Pass in front of the camera from left to right. When
the camera detects motion, the test light blinks to indicate that the
camera would normally have saved a photo or video. If the system
does not detect movement, increase the detection range using the
option «Sensitivity» in the Settings menu ( «Low», «Medium» or
«High»). Realign the system if necessary.
how the device responds to detections, you can better adjust the
direction or the height of the camera.
to allow the user to leave the area
A countdown is also displayed on the
to leave the
A countdown is also displayed on the
Once you understand
How to properly install your camera
using the supplied installation strap:
(Recommended installation height: about 3 feet)
In «Test» mode, it is possible to take a picture by pressing the
«OK» button. The photo is saved and appears in «View» mode.
The «Test» mode also provides information on:
1. The battery level
2. The used space on the memory card (as a percentage)
1.
11
2.