Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
24
«MYSPYPOINT» MODE
When the WiFi camera is connected to an
Features:
existing network, it can use mySPYPOINT
service to host pictures. Therefore you can
quickly and easily access your photos from
anywhere using a Smartphone, a computer or r
a tablet. Online configuration of the camera
is also possible via mySPYPOINT website
(subscription required).
When configuring:
(Follow the steps on the camera screen)
N
Name of the
When entering the name of the camera, it is
camera
possible to select up to 20 characters. Use but-
tons
«
bers and use buttons «
from right to left in the name. Press «OK» only
when the name is completed.
Test the
• Select an existing Wi-Fi network in the
screen of the camera.
connection
• Enter the password of the
possible to select up to 20 characters. Use
buttons
numbers and use buttons «
to move from right to left in the name. Press
«OK» only when the name is completed.
• Verify that all configuration settings are
correct.
• Confirm the configuration and test the
connection. When the connection test is
completed, press «OK» on the camera.
It is possible to view photos, see the status of
Camera setup/
the camera and change its configuration via the
Viewing photos
website www.mySPYPOINT.com (subscription
required)
▲
▼
» and «
» to change letters or num-
◄
►
» and «
» to move
network; it is
«
▲
» and «
▼
» to change letters or r
◄
» and «
REMOS TECHNOLOGY
This Remos compatible camera benefits from wireless capabilities
and can be combined with:
• RC-1 ― Remote control (control of the camera remotely)
• MS-1 ― Motion sensor (trigger of the camera remotely)
• IRB-W ― Infrared Booster (increases the lighting power)
Refer to the section
Note: The optional steel security box (SB-92) affects wireless
functionalities of products compatible with Remos technology.
REMOTE CONTROL
Synchronize
Remote control
►
»
Using the remote control
Light features
f
«Settings»
for details
Turn on the camera and leave the screen open
:
to the main menu. To synchronize the remote
control to the camera, press simultaneously
the «ON» and «FN» buttons. The red and
green lights will flash a few moments before
turning on and after, turning off. If the lights
are flashing constantly, it means that the
synchronization did not work. Try again.
Note: It is important that the «Remote» option
in the «Settings menu» is enabled.
:
The red light flashes when the remote control
sends a signal. When the camera has received
this signal, the green light.
25
Publicité
Table des Matières
