Spypoint S-WiFi Manuel D'utilisation page 12

22
«HOME SECURITY
» MODE
The Wi-Fi camera can be connected to an
Features:
existing Wifi network. This mode enables
monitoring when using a computer connected
to this same network.
When configuring:
(Follow the steps on the camera screen)
Name of the When entering the name of the camera, it is
possible to select up to 20 characters. Use but-
camera
tons «
bers and use buttons «
from right to left in the name. Press «OK» only
when the name is completed.
Test the
For testing the connection, it is important
that the SD card from the camera has been
connection
configured
manager» software and this software must be
active. (See «SPYPOINT Security manager
software» section)
• Select an existing Wi-Fi network in the
screen of the camera.
• Enter the password of the
possible to select up to 20 characters. Use
buttons
numbers and use buttons «
to move from right to left in the name. Press
«OK» only when the name is completed.
• Verify that all configuration settings are
correct.
• Confirm the configuration and test the
connection. When the connection test is
completed, press «OK» on the camera.
▲ ▼
» and « » to change letters or num-
◄ ►
» and « » to move
with «SPYPOINT
network; it is
« ▲ » and « ▼ » to change letters or
◄ » and «
Viewing photos:
SPYPOINT
Security
manager
software:
(Available on www.
spypoint.com)
Security
► »
It is possible to view pictures from a computer.
Open the folder where you chose to save your
photos during the system configuration (with the
«SPYPOINT Security manager» software)
(See next section)
Allows to view photos from a computer.
Using the software:
Follow the steps on the camera screen.
-The «Start new configuration» option is
selected when the software must be used for
the first time on a computer or during the
configuration of the system before the use a
new SD card or a new camera.
-The «Use actual configuration» option is
selected to reactivate the software following
the shut down of the computer.
To view on your computer the new photos
taken by the camera, open the software and start
a synchronization with the remote control (See
«Remote control» section) or just wait the next
synchronization of the camera. (The camera
must be in «PHOTO» or «VIDEO» mode ).
The new photos will be transferred to the folder
where you chose to save your photos during the
system configuration.
Note : The name of the images downloaded by
the software starts by
SPLG.
23