Power Supply - Spypoint S-WiFi Manuel D'utilisation

6
Configuration of the
camera:
Softwares:
:
Technology Remos
Recommendations:
Operating temperature
Storage temperature
CONTENTS
• SPYPOINT WiFi camera
• RC-1 Remote control
• Wi-Fi antenna 2.4 GHz
• Installation strap
• USB and audio-video cables
• User Manual
• For Hunting mode, the camera
« »
can be configured remotely on the
website www.nameofthecamera.com
via the activation of Wifi camera
network with the remote control.
• For Home Security mode, can
« »
only be configured from the camera.
• For mySPYPOINT mode,
« »
the camera can be configured
mySPYPOINT
from website
(subscription required).
• The software « SPYPOINT Security
manager» and «SPYPOINT Hunting
photos downloader» are available on
www.spypoint.com
• These softwares are compatible with
Windows only.
This camera is compatible with
Spypoint Remos Technology (see
«Remos Technology» section).
(-20 °C to + 50 °C)
(-4 °F to +122 °F)
(-30 °C to + 75 °C)
(-22 °F to +167 °F)

POWER SUPPLY

The battery level is shown in the upper left corner of the screen
when the camera is in « Test » mode. When a single line remains, the
camera will continue to take pictures but we strongly recommend
changing the batteries before they are empty (see figure below).
AA BATTERIES
This camera requires the use of 8 AA batteries (1.5V). The use of
alkaline or lithium batteries is strongly recommended. Also note
that the voltage of rechargeable AA batteries (1.2V) is insufficient
to power this camera. During the installation of AA batteries, place
the switch inside the battery case to «ALK» (i.e. alkaline). Insert
the batteries in the camera as indicated. Exact polarity must be
followed. We also recommend the use of new batteries to ensure
maximum performance of your camera.
LITHIUM BATTERY PACK
The camera can be powered by a rechargeable lithium battery pack
LIT-09/LIT-C-8 (sold separately, see «Options»). This type of
battery is less affected by cold temperatures and lasts up to 3 times
longer than alkaline batteries. During the installation of lithium
batteries, place the switch inside the battery case to «LIT-09». Insert
the batteries in the camera as indicated (see figure below).
RESET
7
ALK
LIT-09