Location And Connection - EUROM 342697 Manuel D'utilisation

Remote control
A. On/off (standby) button
B. Function selection button
- Low power heating
- High power heating
C. Oscillator/swivel button
D. Timer key
E. Temperature setting button
F. Temperature higher
G. Temperature lower
The remote control works on a button cell battery, Type
CR2025 (3V).

Location and connection

Remove all packaging material and keep out of reach of children. After removing

packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact
your vendor for inspection or replacement.
Select a suitable location for the device taking into account all the

aforementioned warnings in this manual.
 Place the 2 supporting brackets supplied with the screws on either side
of the handle.
Check to make sure the on/off switch is set to 'OFF' (O).

Unwind the electrical cable completely and insert the plug into a suitable 220-

240V socket. To prevent overloading, check that no other equipment is
connected to the same group.
Note: The heater can be used both vertically
heating capacity is optimal in the vertical position, however.
and horizontally
35
. The