EUROM 342697 Manuel D'utilisation page 37

numbers on the screen start flashing. The desired temperature can be set with
the + and - button. The set temperature flashes 5x, then the display displays
the ambient temperature again. See figures 12 and 13.
Press the
continue to heat continuously without taking into account a set temperature.
Note 1: The heater will start heating when the set temperature is at least 3
degrees higher than the measured ambient temperature.
Note 2: When the set temperature is reached, the heater will stop heating and the
fan will continue to run for 60 seconds to blow the residual heat out of the heater.
The heater will start heating when the set temperature is at least 3 degrees below
than the measured ambient temperature.
Switching off with remote control
7. Press to put the heater on standby, the fan will only cool down for 60
seconds to blow the residual heat out of the device when the heater is in heating
mode: the display counts down the seconds and the fan indicator light stays on.
To switch the heater off fully, press the on/off button
remove the plug from the socket. If the heater is not working, always remove the
plug from the socket.
Security
Anti-tilt protection
The device is equipped with anti-tilt protection that shuts off the device if it
accidentally tips over. As soon as you put it upright again, the heater returns to
standby mode but switch it off first, remove the plug from the socket and check the
heater for damage. In the event of damage or abnormal functioning, do not use it
and take it for inspection/repair!
Overheating protection
The overheating protection switches the device off if it becomes too hot inside. This
can happen if the device is unable provide sufficient heat or draw in enough fresh
air. The cause is usually because the device is (partially) covered, the air inlet or
outlet openings are blocked, or it has been placed to close to a wall, for example.
Once the device has cooled down sufficiently, it should automatically resume
button again to stop the temperature setting. The heater will then
37
to 'o' and