EUROM 342697 Manuel D'utilisation page 36

Operation
Operating manually
1. Press the on/off button
temperature and all function images briefly, see figures 1 and 2. The heater is
now in standby.
2. Pressing x1 on
3. Pressing x2 on
4. Pressing x3 on
5. Pressing x4 on
function, see figure 5.
Switching off manual operation
6. Pressing x5 on
cool for 60 seconds while the display counts down the seconds and the fan
indicator light stays on, see figure 7.
Operating with remote control
1. Press the on/off button
temperature and all function images briefly, see figures 1 and 2. The heater is
now in standby.
2. Switch the heater on with the
3. Press once to
Press twice
Press three times
4. Press to oscillate (swivel) the heater, see figure 8, press again and the
oscillator (swivel) stops.
5. Use the timer button to set the time, after which the device switches itself
off. Each time you press this button, the set time will increase by half an hour
(0.5 hours to 7.5 hours). The timer symbol appears on the screen
can be set from 1 to 7.5 hours, see figures 9, 10 and 11.
6. Press (temperature setting button) to set the desired temperature. Please
note that this button only works when the heater is in heating mode, not in
ventilation mode! The thermostat symbol appears on the screen and the
turns on the heater fan, see figure 3.
turns on the heater at low power, see figure 4.
turns on the heater at high power, see figure 5.
turns on the heater at high power and the oscillator (swivel)
turns the heater back on to standby, and makes it continue to
turn on the heater at low power.
to turn on the heater at high power.
to turn on the heater fan. See figures 3, 4 and 5.
on '-' = on. The display shows the ambient
to '-'=on. The display shows the ambient
button. The heater fan will start to blow.
36
. The time