Bresser BF-PRO Mode D'emploi page 32

H) HOW TO CHECK REMOTE TEMPERATURES
The wave display on the outdoors temperature indicates the
reception of the remote unit is in good order.
If no readings are received from the remote unit for more than
two minutes, blanks " " will be displayed until further readings
are successfully searched. Check the remote unit is sound and
secure. You can wait for a little while or Hold [▼] for 2 seconds
to enforce an immediate search.
If the temperature goes above or below than the temperature
measuring range of the main unit or the remote unit (stated in
specifi cation), the display will show " ".
I) HOW TO READ THE KINETIC WAVE DISPLAY
The kinetic wave display shows the signal receiving status of the
main unit. There are three possible forms:
The unit is in searching mode.
Temperature readings are securely registered.
˚C
No signals.
DISCONNECTED SIGNALS
If without obvious reasons the display of the outdoor temperature
goes blank, Hold [▼] for 2 seconds to enforce an immediate search.
If that fails, check:
1. The remote unit is still in place.
2. The batteries of both the remote unit and main unit.
Replace as necessary.
32