Door Closing; Refrigerator Use; Normal Sounds; Using The Control - Jenn-Air JUR24FRACX Guide D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Door Closing

Door Closing
Your refrigerator has four leveling legs. If your refrigerator seems
unsteady or you want the door to close more easily, adjust the
refrigerator's tilt using the instructions below.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1. Plug into a grounded 3 prong outlet.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other injury.
2. Move the refrigerator into its final location.
3. Turn the leveling legs to the right to lower the refrigerator or
turn the leveling legs to the left to raise it. It may take several
turns of the leveling legs to adjust the tilt of the refrigerator.
NOTE: Having someone push against the top of the
refrigerator takes some weight off the leveling legs. This
makes it easier to adjust the leveling legs.
4. Open the door again to make sure that it closes as easily as
you like. If not, tilt the refrigerator slightly more to the rear by
turning both front leveling screws to the left. It may take
several more turns, and you should turn both leveling legs the
same amount.

REFRIGERATOR USE

Normal Sounds

Your new refrigerator may make sounds that your old one didn't
make. Because the sounds are new to you, you might be
concerned about them. Most of the new sounds are normal. Hard
surfaces, such as the flooring and surrounding structures, can
make the sounds seem louder. The following describes the kinds
of sounds and what may be making them.
Your refrigerator is designed to run more efficiently to keep
your food items at the desired temperatures and to minimize
energy usage. The high efficiency compressor and fans may
cause your refrigerator to run longer than your old one. You
may also hear a pulsating or high-pitched sound from the
compressor or fans adjusting to optimize performance.
Rattling noises may come from the flow of refrigerant or items
stored inside the refrigerator.
As each cycle ends, you may hear a gurgling sound due to the
refrigerant flowing in your refrigerator.
You may hear water running into the drain pan when the
refrigerator is defrosting.
You may hear clicking sounds when the refrigerator starts or
stops running.

Using the Control

The control is located behind the base grille. Lift up on the door in
the center of the grille to access the control.
For your convenience, your refrigerator temperature control is
preset at the factory. When you first install your refrigerator, make
sure that the control is still preset to the mid-setting as shown.
Adjusting Controls
The mid-setting should be correct for normal usage. The control is
set correctly when beverages are as cold as you like.
If you need to adjust the temperature, wait at least 24 hours
between adjustments and then recheck the temperature.
To make the refrigerator colder, adjust the control to the next
higher setting. To make the refrigerator less cold, adjust the
control to the next lower setting.
9

Publicité

Table des Matières
loading

Table des Matières