We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING."
These words mean:
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
IMPORTANT:
These instructions are intended as a general guide only and do not
supersede any national or local codes in any way. Compliance with
all local, state or national codes pertaining to this type of
installation should be determined prior to installation.
These instructions are intended to supplement the Installation
Instructions provided with your refrigerator not replace them.
Follow the instructions provided with the refrigerator to install it
into the cabinet.
A hardware bag is shipped with the refrigerator. You will find the
hardware bag in either one of the crisper drawers or attached to
the outside of one of the refrigerator doors.
NOTE: The hardware bag contains all the parts and fasteners
needed to install custom wood panels. Most of these components
have been preinstalled on the panels included in this kit.
Tools and Parts
Assemble the required tools and parts before starting installation.
Read and follow the instructions provided with any of the required
tools listed here. Proper installation is your responsibility.
Tools Needed:
Cordless drill
Drill bits
³⁄₈" and ¹⁄₂" Open-end
wrenches or two
adjustable wrenches
Phillips screwdriver
Small level
DOOR PANEL KIT SAFETY
Your safety and the safety of others are very important.
DANGER
WARNING
INSTALLATION REQUIREMENTS
Appliance dolly
³⁄₃₂", ⁵⁄₃₂" and ³⁄₁₆" Hex key
¹⁄₄" and ⁵⁄₁₆" Socket
drivers
Tape measure
Utility knife
Tape (painters)
You can be killed or seriously injured if you don't immediately
follow instructions.
You can be killed or seriously injured if you don't follow
instructions.
Parts Supplied with Panel Kit:
Exterior door panels with
handles and mounting
hardware preinstalled.
Instructions
Parts Supplied with Refrigerator (Needed to Install Panel Kit):
Phillips-head flat screw
White: 8281251
Black: 8281252
Parts Supplied with Refrigerator (Needed only if it is necessary to
reduce the door swing to 90°):
Door Stop Pin
W10234202
Refrigerator access grille
with mounting hardware
preinstalled
Access grille vent trim
Slotted hex-head screw
W10141645
3