Door Closing - Jenn-Air Euro-Style Série Guide D'utilisation Et D'entretien

5. Then, fasten the custom panel to the door using two wood
screws (provided in installation kit) at each corner.
NOTE: Do not use the same screws that were previously
removed.
A
A. M4 x 14 wood screws
6. Press the gasket firmly back into it's original position.
7. For 8" (203 mm) or 6¹⁄₄" (160 mm) custom handles, install the
custom handle from the inside/back of the refrigerator door
using screws provided with the handle.
8 8 8
A

Door Closing

Door Closing
Your refrigerator has four leveling legs. If your refrigerator seems
unsteady or you want the door to close more easily, adjust the
refrigerator's tilt using the instructions below.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1. Plug into a grounded 3 prong outlet.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other injury.
2. Move the refrigerator into its final location.
3. Turn the leveling legs to the right to lower the refrigerator or
turn the leveling legs to the left to raise it. It may take several
turns of the leveling legs to adjust the tilt of the refrigerator.
NOTE: Having someone push against the top of the
refrigerator takes some weight off the leveling legs. This
makes it easier to adjust the leveling legs.
4. Open the door again to make sure that it closes as easily
as you like. If not, tilt the refrigerator slightly more to the rear
by turning both front leveling screws to the left. It may take
several more turns, and you should turn both leveling legs the
same amount.