Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Product Dimensions
IMPORTANT:
The depth from the front face of the doors to the back of the
refrigerator cabinet is 24" (60.96 cm) without panels.
The power cord is 84" (213 cm) long.
The water supply line is located at the front of the refrigerator.
Top View
24"
(61.0 cm)
Model
42
48
Front View
Width dimensions were measured from hinge to hinge.
A
(see chart following)
Model
Width A (hinge edge to hinge
edge)
42
41³⁄₄" (106 cm)
48
47³⁄₄" (121.3 cm)
A
A
41³⁄₄" (106 cm)
47³⁄₄" (121.3 cm)
*84"
(213.4 cm)
Tipping Radius
Be sure there is adequate ceiling height to stand the refrigerator
upright when it is moved into place.
The dolly wheel height must be added to the tipping radius
when a dolly is used.
If needed, the tipping radius can be reduced. See "Reduce
Tipping Radius."
Side Tipping Radius
The side tipping radius varies depending upon the width of the
model. Use the chart provided to determine the side tipping
radius.
NOTE: Tip on side only.
A
Model
42
48
Door Swing Dimensions
The location must permit both doors to open to a minimum of 90°.
Allow 4¹⁄₂" (11.4 cm) minimum space between the side of the
refrigerator and a corner wall.
NOTE: More clearance may be required if you are using wood
overlay panels, custom handles, or extended handles.
A
B
90˚
110˚
Model
A
42
40³⁄₄"
39³⁄₄"
(103.5 cm)
(101.0 cm)
48
43¹⁄₄"
42"
(109.9 cm)
(106.7 cm)
Tipping Radius A
91³⁄₈" (232.1 cm)
94³⁄₈" (239.7 cm)
90˚
110˚
B
C
45³⁄₈"
46³⁄₄"
(115.3 cm)
(118.8 cm)
48⁵⁄₈"
50¹⁄₄"
(123.5 cm)
(127.6 cm)
C D
D
9
Publicité
Table des Matières
