sylvac WORK NANO Mode D'emploi page 12

7 Entering a numeric value
E
To enter or modify a numeric value (Preset, nominal ratings, tolerance intervals or multiplication factor), you can proceed
in two ways :
B
OK
H
IN
mm
thou
TOL MINMAX PRESET
µm
7.1 Increases / decrases the current value :
Decreases the current value
Increases the current value
Note: - the scanning speed increases with a long press on the button
- save the value with one of the three lower buttons
7.2 Entering digit by digit :
Increase of the selected digit
SET
Selection of the next digit
Save the value
MODE
12