sylvac WORK NANO Mode D'emploi page 11

6.2 Use of the buttons
It is also possible to enter or modify the nominal value or the tolerance limits by prolongedly pressing (>2s) the
Enter the
or button :
nominal rating
+
(see chap. 7)
Note :
- It is also possible to display the tolerance limits when the instrument is operating in MIN, MAX or DELTA (TIR) mode.
- If no tolerance limits have been defined by the user, the instrument will only display the tolerance limit indicators but will
not turn on the indicator lights (red - green - yellow).
- In case of measuring internal ratings, you can cross the indicators (red and yellow) by reversing the order of entering the
tolerance intervals (upper interval < lower interval).
and :
mm
MODE
OK
mm
TOL
Enter the
lower interval
mm
MODE
mm
TOL
(see chap. 7)
11
a n d /
Enter the
upper interval
mm
MODE
mm
TOL
(see chap. 7)
E