Audio Inputs; Switching On; Pairing In Tx Mode - Marmitek BOOMBOOM 100 Guide Utilisateur

4.2.1

Audio inputs

The audio inputs are only used when the BoomBoom 100 is set as
a transmitter. If the BoomBoom 100 is set as a transmitter, it
requires an audio source to send audio wirelessly. This source
can be a TV, game console, computer, mp3 player, etc.
4.2.2

Switching on

Slide the TX/Off/RX switch to the TX position.
The blue LED will now start to blink slowly, indicating that the
BoomBoom 100 is switched on.
4.2.3

Pairing in TX mode

Connect the BoomBoom 100 to your TV or computer using the
correct cable (C, D or E). You can now pair the BoomBoom 100
with a pair of Bluetooth headphones or a speaker.
Place your headphones or speaker within 1 metre of the
BoomBoom 100 and put it into pairing mode.
Slide the multifunctional switch (2) all the way to the right (BT).
The LED will now start to blink red/blue, indicating that the
BoomBoom 100 is ready for pairing. Now slide the multifunctional
switch back to the centre position for optical connection (OPT), or
all the way to the left for analogue connection (AUX).
The BoomBoom 100 and your headphones or speaker should
both be in pairing mode to establish a connection. The
BoomBoom 100 will remain in pairing mode for up to 30 seconds
until the connection has been established. Once the connection
has been established, the LED will turn blue or green.
BoomBoom 100 9