Safety Instructions - Güde JG 1000 E Traduction Du Mode D'emploi D'origine

ENGLISH
14
Do not leave the pump unattended while in
operation in order to prevent subsequent
damages caused by eventual malfunctions. Make
sure to disconnect the device from the grid if you
do not plan on using it.
Do not use the pump for drinking water!
The pump must not be connected to the
existing water-supply network as a pressure-
boosting device.
Never use the pump as a pool circulation
pump.

Safety Instructions

WARNING!
Electric shock! There is a risk of an injury caused
by electric shock!
This device is not intended for use by persons (inclu-
ding children) with limited physical, sensory or mental
capabilities or without the necessary lack experience
or knowledge unless they are supervised by a person
who is responsible for their safety or were instructed
by that person in how to use the device.
Children should be supervised to ensure that they do
not play with the device. Always keep children and
unauthorised persons out of reach of the appliance.
Operation is only allowed with a safety switch
against stray current (RCD max. stray current of
30mA).
Before putting into operation, a qualified electrician
must check whether electric safety measures required
are in place. Any national regulations in this regard
must be complied with.
Electric connection to a socket.
Do not expose the appliance to rain and do not use it
in wet or moisture conditions.
It is necessary to make sure the connecting socket
was not near water and humidity and the plug was
protected against humidity.
Avoid installing the appliance in wet shafts (risk of
short circuit, corrosion effects)!
Check the voltage. Technical data given on the type
label must correspond with electric network voltage.
Only use splash proof extension cables approved for
outdoor purposes.
Do not grab the feeder cable, plunge the pump, lift or
carry it while it is connected to the grid!
Check the cable and/or socket for damages before
the appliance putting into operation.
To avoid danger, a damaged mains supply pipe must
be replaced by the manufacturer. Do not under any
circumstances attempt any repair yourself.
Protect the feeder cable from excessive temperatures,
oil and sharp edges.
If the pump is in operation, neither people nor
animals can be present or plunged in the pumped
liquid (e.g. pools, cellars, etc.).
The pump must not in any case run without
fillings.
Do not leave the pump unattended while in operati-
on in order to prevent subsequent damages caused
by eventual malfunctions. Make sure to disconnect
the device from the grid if you do not plan on using it.
The temperature of the drained liquid must not
exceed +35 °C.
When using the pump for domestic water supply,
alwaysobserve the local regulations of water manage-
mentauthorities and the waste water drainage.
If the pump is used in ponds, wells, etc. and appropri-
ate pumping stations, standards valid for pumps in
the given country must unconditionally be observed.
Do not use pump at outside temperatures over 40 °C
or under 0 °C
In cold weather, the pumping body motor should not
bewrapped in a blanket or another piece of textile
with intent toprevent the water freezing.
The user is responsible to third parties if pump (dum-
ping stations, etc.) is used.
Requirements for operating staff
The operating staff must carefully read the Opera-
ting Instructions before using the appliance.
Qualification: Apart from the detailed instructions
by a professional, no special qualification is necessary
for appliance using.
Minimum age: Persons over 16 years of age can
only work on the appliance. An exception includes
youngsters trained in order to reach knowledge
under supervision of the trainer during occupational
education.
Training: Using the appliance only requires corre-
JG 1000 E