Faro MAIA Mode D'emploi page 22

SERVICING/CLEANING
Replacing fuses "6" in the lamp version with transformer
(see description of parts)
The lamp with transformer is supplied with two identical fuses. To replace it, proceed as
described below:
- ensure that power supply is disconnected,
- unscrew caps "6" located on the transformer holder,
- extract the fuses. After observing the interruption, replace the fuses.
CLEANING THE DISHES "3" (see description of parts):
Clean with cotton wool and ethyl alcohol.
Do not use water-repellant or surfactant-based detergents, whose build-up can leave haloes.
STERILIZING THE HANDLES
To remove the handle, unscrew button "A" and slip it off.
To insert it, push fi rmly and screw on "A".
OTHER PARTS OF THE LIGHT (head-articulated arm)
Clean with a soft cloth.
20
Important: the new fuses must have the characteristics indicated on the
information plate and in the technical specifi cations.
For cleaning plastic parts of the lamp MAIA, do not use detergents-disinfectants
containing:
AMMONIUM
METHYLENE CHLORIDE METHYL ALCOHOL
Failure to comply with this indication might cause: risk of breakage of plastic
parts • risk of structural breakdown of hinge joints with potential falling of the
articulated arm. In case of doubt, please contact Customer Care Faro.
Hydro-alcohol disinfectants with 70% isopropyl or ethyl alcohol are suitable.
PLEASE NOTE: other products might damage the refl ectors (dishes).
In case of doubt, please contact Customer Care Faro.
Slight haloes will not impair the quality of light.
Handles are not provided sterile and must,
therefore, be sterilised before use.
Sterilize the device with standard cycles
at 121°/134° C for a total of 200 sterilisation cycles.
For all lamp parts, it is absolutely forbidden to use abrasive substances, detergents
based on trichloroethylene, benzene, turpentine or the like.
HYDROXIDE SODIUM HYDROXIDE
"A"