Faro MAIA Mode D'emploi page 21

INSTRUCTIONS FOR USE
SWITCHES SYMBOL
ON-OFF
"MAIA" LAMP WITH SWITCH (see description of parts)
on-off regulation
- To switch the lamp on/off, press and release the control lever on the left or right side.
- Regulating the lamp:
the lamp switches on at maximum irradiance.
To reduce the light intensity hold the switch lever down on the left hand side (rear view of
the lamp) until the required intensity is obtained. This control cannot be used to increase
the light level. On reaching minimum light intensity, an acoustic signal will be heard (1
beep).
The control joystick must be handled delicately to prevent breakage.
Each time the lamp is turned on, the light intensity will be at the level memorised
when it was turned off the time before.
"MAIA" LIGHT WITH PROXIMITY SENSOR
Turning on and off:
- To switch on and off, move near to the sensor up to a maximum distance of 3 cm
- For light intensity regulation, place the hand near the sensor until desired intensity is
reached, from the maximum to the minimum level and from the minimum to the maximum
level. On reaching maximum intensity, an acoustic signal will be heard (2 beeps); there
will be 1 beep for minimum intensity.
Each time the lamp is turned on, the light intensity will be at the level memorised
when it was turned off the time before.
"MAIA" DENTAL LIGHT SYSTEM WITH REMOTE CONTROL
Remote cable 4 m long. - Maximum protrusion of the remote cable from the arm on the pin
side, 2,5 m.
The remote cable must not be extended during installation. Any work done on
the remote cable may have negative effects in terms of "EMC" performance.
Turning on and off/ Adjustments:
- To switch on/switch off the lamp, press the push-button "A".
- Adjustment:
a) To reduce the light intensity keep the push-button "A" pressed, until the desired inten-
sity is obtained.
When the minimum light intensity is obtained, you will hear an acoustic signal (1 beep).
b) To increase the light intensity keep the push-button "A" pressed, until the desired
intensity is obtained.
When the minimum light intensity is obtained, you will hear an acoustic signal (2 beeps).
c) To immediately obtain the minimum light intensity, press the push-buttons "B".
When the minimum light intensity is obtained, you will hear an acoustic signal (1 beep).
Press the button again to restore previously selected light intensity.
Each time the lamp is turned on, the light intensity will be at the level memorised
when it was turned off the time before.
(see the description of parts)
(see the description of parts)
19 19