Custom Handle (Optional); Electrical Requirements; Installation Instructions; Unpack The Refrigerator - Jenn-Air Euro-Style Série Guide D'utilisation Et D'entretien

Custom Handle (optional)

Overlay Door Models Only
Custom handles are typically attached to the custom overlay
door panel only. There are two custom handle locations provided
on the refrigerator where the handle may be attached through the
custom overlay door panel and to the inside of the refrigerator
door for enhanced stability. The two locations provided
accommodate popular kitchen cabinet pull/handle sizes of
8" (203 mm) and 6¹⁄₄" (160 mm).
1. Follow the instructions to make the custom overlay panel.
2. See the following dimension drawings for custom handle
specifications.
3. Drill custom handle holes to match the size of your custom
handle—8" (203 mm) or 6¹⁄₄" (160 mm).
4. Install custom handle before installing overlay panel on
refrigerator door.
A. 8" (203 mm) handle holes
B. 6" (160 mm) handle holes
C. Drill holes using a
(4.5 mm) drill bit (2 holes)
NOTE: Custom handles that are placed in a different location
(see preceding drawing) or are not the recommended size
(8" [203 mm] or 6¹⁄₄" [160 mm]) need to be installed on the door
panel with countersunk holes and installed before the custom
overlay door panel has been installed on the refrigerator door.
6 6 6
³⁄₁₆
"

Electrical Requirements

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Before you move your refrigerator into its final location, it is
important to make sure you have the proper electrical
connection.
Recommended Grounding Method
A 115 volt, 60 Hz., AC only, 15– or 20–amp fused, grounded
electrical supply is required. It is recommended that a separate
circuit serving only your refrigerator be provided. Use an outlet
that cannot be turned off by a switch. Do not use an
extension cord.
NOTE: Before performing any type of installation, cleaning, or
removing a light bulb, unplug refrigerator or disconnect power.
INSTALLATION
INSTRUCTIONS

Unpack the Refrigerator

WARNING
Excessive Weight Hazard
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other injury.
Remove the Packaging
Remove tape and glue residue from surfaces before turning
on the refrigerator. Rub a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with warm water
and dry.
Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your refrigerator. For
more information, see "Refrigerator Safety."