Assembling The Mast To The Base; Preparing The Lift For Use - Invacare Stand Assist Reliant RPS350-1E Manuel D'utilisation

Invacare® Stand Assist

3.2 Assembling the Mast to the Base

WARNING!
– Use only Invacare parts in the assembly of this patient
lift. The base legs, the mast, boom, pump assembly
and swivel bar are manufactured to specifications that
assure correct alignment of all parts for safe functional
operation.
DETAIL A
A Hex Bolt
B Washer
The mast assembly may be removed from the base for
storage or transporting. The mast assembly MUST be
properly secured to the base assembly before use.
1. Put the base on the floor.
Make sure all four casters make contact with the floor.
2. Lock both rear casters Refer to Detail A.
3. Remove the hex bolt, washers and nut that are located in the
U-shape cut-out of the base Refer to Detail B.
14
DETAIL B
C Nut
D Mounting Bracket
4. Lift the mast to an upright position.
5. Lower the mast onto the mounting bracket.
6. Attach the mast to the base with the hex bolt, washers and nut.
Tighten securely.

3.3 Preparing the Lift for Use

Check and tighten all hardware BEFORE use.
1078985-G