Usb Connection - VOLTCRAFT PL-125-T2USB Mode D'emploi

tiE
rAt
CLR1
TI OFFSET
T2 OFFSET
5. To return to the normal display mode, press and hold the SET button.
determining any deviation of a sensor's measurement accuracy
1. Turn the thermometer on and place the relevant sensor in an optional temperature calibrator or in
any other reference location with a known and stable temperature.
2. Wait until the thermometer's display has stabilised.
3. If there is a difference, you can manually compensate it (see section "Adjusting settings").
10.

USB CoNNECTIoN

1. Insert the mini USB plug of the mini USB cable into the USB socket (6) of the measuring
instrument.
2. Insert the USB plug of the mini USB cable into a vacant USB port on a personal computer (PC).
3. Start the software "Multiple Data Logger" and follow the instructions under the "Help > Help
topics".
28
Time setting •
•
•
Sampling rate •
•
•
•
Clear memory •
•
T1 offset value Set the offset value of measurement T1.
T2 offset value Set the offset value of measurement T2.
Press the button ◄ MAX MIN button to switch between
the values in the time setup page.
The top four digits show the year setting (YYYY),
below it, you will find the month setting and the date
setting (MMDD).
At the bottom part of the display, you will find the time
setting. (HH:MM).
Set the sampling rate for real-time display / recording.
You will see the current sampling rate (mm:ss) after
entering the setup page.
Press the ◄ MAX MIN button to switch between the
values in the time setup page.
Press the ▲T1·T2 button (2) or HOLD ▼ button (7)
to adjust the value.
Shows the amount of empty memory.
Clear the internal memory. Select YES to clear and no
to keep the memory.