VOLTCRAFT PL-125-T2USB Mode D'emploi page 27

• ▲T1·T2 button
Press once:
-
-
Press twice:
Press
-
twice:
-
-
Press three times:
- Switch back to real-time and minimum reading of T1.
• The real-time reading of T1 appears on top.
• The average value (AVG) of the current measurement process of T1 appears
underneath.
• The running total time of the current measurement process is displayed at lower edge
of the display in minutes and seconds (min:sec) or in hours and minutes (hour:min).
• ▲T1·T2 button
Press once:
-
Press
three -
times:
Press twice:
-
-
-
Press three times:
-
Press and hold the MAX/MIN button for approx. two seconds to return to normal display mode.
26
Switch the real-time reading from T1 to T2.
Shows the minimum reading (MIN) of the current measurement process of
T2.
Shows the current readings' difference (T1 - T2) on top.
Shows the minimum difference underneath.
Point in time, at which the minimum difference is measured, is displayed at
lower edge of the display in minutes and seconds (min:sec) or in hours and
minutes (hour:min).
Switch the real-time reading from T1 to T2.
Shows the average reading (AVG) of the current measurement process of T2.
Shows the current readings' difference (T1 - T2) on top.
Shows the average difference underneath.
The point in time, at which the average difference is measured, is displayed
at lower edge of the display in minutes and seconds (min:sec) or in hours and
minutes (hour:min).
Switch back to real-time and average reading of T1.