Adjusting Settings - VOLTCRAFT PL-125-T2USB Mode D'emploi

Recording function
1. Press and hold the REC ENTER button (5) for approximately three seconds during any
measurement to record the measured values. The word REC will be displayed on the screen when
the measured values are being recorded. If the memory is full, the word REC will flash. Follow the
instructions in the sub-chapter "Adjusting settings" to clear the memory.
2. Press and hold the REC ENTER button (5) again for approximately three seconds to stop
recording.
Data can only be retrieved via the software. Refer to the chapter SOFTWARE INSTALLATION
for software installation information. Refer to the chapter OPERATION > Adjusting Settings to
change the sampling rate of the new records.
Hold function
1. Press the HOLD ▼ button (7) during any measurement to freeze the measurements. The word
HOLD will be displayed on the screen when the measured values are being recorded.
2. Press the HOLD ▼ button (7) to unfreeze the measurements.

Adjusting settings

1. Press and hold the SET button (10) to enter the set up mode. SETUP will appear on the lower
part of the display.
2. Press the ▲T1·T2 button (2) or HOLD ▼ button (7) to switch between the setting parameter.
3. Press the REC ENTER button (5) to enter the setup page of the parameter.
4. In the setup page of a parameter, press the ▲T1·T2 button (2) or HOLD ▼ button (7) to adjust
the value.
display
Type
SLP
Parameter description
Sensor type Select between J type or K type sensor.
Auto turn off •
mode
•
Turn the auto turn off mode on (on) or off (oFF) .
When the sleep mode is turned on, the measuring
instrument will be turned off when it is idle for 15
minutes.
27