Mounting The Loop Handle - Stihl FS 56 Notice D'emploi

English

Mounting the Loop Handle

A factory-new machine comes with the
loop handle already mounted.
Using the Barrier Bar
A barrier bar may have to be mounted to
suit the cutting attachment you intend to
use – see "Approved Combinations of
Cutting Attachment, Deflector, Handle
and Harness".
The barrier bar comes standard with the
machine or is available as a special
accessory.
14
Mounting the Barrier Bar
1
1
2
2
5
5
3
3
Take out the screws (1) and remove
N
along with washers (2) and nuts (3).
Remove the loop handle (4) and
N
clamps (5).
3
Fit the square nuts (3) in the barrier
N
bar (6); the holes must line up.
4
4
8
9
1
Place the clamp (7) in the loop
N
handle (4) and position them both
against the drive tube (8).
Position the clamp (8) against the
N
drive tube.
Place the barrier bar (6) in position
N
as shown.
Line up the holes.
N
Insert the screws (1) in the holes
N
and screw them into the barrier bar
as far as stop.
3
Go to "Adjusting and Securing the
N
Loop Handle".
Leave the barrier bar permanently
mounted to the loop handle.
FS 56, FS 56 R, FS 56 C, FS 56 RC
6
7
1