Mounting The Loop Handle; Mounting The Deflector - Stihl FS 45 Notice D'emploi

Mounting the Loop Handle

Place the friction liner in the loop
N
handle.
FS 45, FS 46
A
1
6
5
3
4
Fit the loop handle (1) on the drive
N
tube at distance (A) of about 20 cm
(8 in.) from the control handle (2).
Slide the spacer (3) – if supplied –
N
into the loop handle as far as
possible.
Insert the screw (4) through the loop
N
handle and the spacer until the
screw head locates in the loop
handle's hexagon recess.
Fit the washer (5).
N
Fit the wingnut (6) and tighten it
N
down firmly.
Adjusting loop handle to most
comfortable position
Loosen the wingnut (6).
N
Move the loop handle (1) along the
N
drive tube as required.
Tighten down the wingnut (6) firmly.
N

Mounting the Deflector

2
2
Push the deflector (1) over the
N
clamp (2) as far as stop.
4
Insert the nut (3) in the hex recess in
N
the deflector – make sure the holes
line up.
Insert the screw (4) and tighten it
N
down firmly.
English
1
3
11