Mounting The Loop Handle - Stihl FS 90 Notice D'emploi

English
Swivelling the handlebar
Transport position
3
7
Loosen the wing screw (3) and
N
unscrew it until the handlebar (7)
can be turned clockwise.
Turn the handlebar 90° and then
N
swing the handles down.
Tighten down the wing screw (3)
N
firmly.
Working position
Reverse the sequence described
N
above to swing the handles up and
turn the handlebar
counterclockwise.
16

Mounting the Loop Handle

Mounting Loop Handle with Barrier Bar
2
1
Fit the square nuts (1) in the barrier
N
bar (2); the holes must line up.
4
5
6
1
Place the clamp (3) in the loop
N
handle (4) and position them both
against the drive tube (5).
Position the clamp (6) against the
N
drive tube.
Place the barrier bar (2) in position
N
as shown.
Line up the holes.
N
Insert the screws (7) in the holes
N
and screw them into the barrier
bar (2) as far as stop.
Go to "Securing the Loop Handle".
N
2
3
7
FS 90, FS 90 R