Mounting The Bike Handle - Stihl FS 56 Notice D'emploi

English
Approved Combinations
Select correct combination from the
table according to the cutting
attachment you intend to use.
WARNING
For safety reasons only the cutting
attachments, deflectors, handles and
harnesses shown in each row of the
table may be used together. No other
combinations are permitted – risk of
accidents.
Cutting Attachments
Mowing heads
1 STIHL SuperCut 20-2
2 STIHL AutoCut C 25-2
3 STIHL AutoCut 25-2
4 STIHL AutoCut C 26-2
5 STIHL TrimCut 31-2
6 STIHL DuroCut 20-2
7 STIHL PolyCut 20-3
Metal cutting attachments
8 Grass cutting blade 230-2
(230 mm dia.)
9 Grass cutting blade 230-4
(230 mm dia.)
10 Grass cutting blade 230-8
(230 mm dia.)
WARNING
Non-metal grass cutting blades are not
approved.
12
Deflectors
11 Deflector with blade, for mowing
heads
12 Deflector for metal cutting
attachments
Handles
13 Loop handle
14 Loop handle with
15 barrier bar
16 Bike handle
Harnesses
17 Shoulder strap may be used
18 Shoulder strap must be used
19 Full harness may be used

Mounting the Bike Handle

Mounting the Handlebar
Mount the handlebar on the drive tube
about 10 cm (4 in) forward of the engine
housing.
3
5
4
1
6
Place the handle support (1) on the
N
drive tube (2).
Place the handlebar (3) in the
N
handle support.
Fit the clamp (4) on the handle
N
support. Insert the screws (5)
through the holes in the parts and
screw them into clamp (6) as far as
stop – tighten them only moderately
at this stage.
FS 56, FS 56 R, FS 56 C, FS 56 RC
2