Mounting The Loop Handle; Adjusting The Throttle Cable; Fitting The Carrying Ring - Stihl FS 111 RX Notice D'emploi

Mounting the Loop Handle

A
2
3
Mount the loop handle (1)
N
about 8 in/20 cm (A) forward of the
control handle (2).
Line up the loop handle.
N
Tighten down the screws firmly.
N
The sleeve (3) must be between the
loop handle and the control handle.
FS 111 RX

Adjusting the Throttle Cable

It may be necessary to correct the
adjustment of the throttle cable after
assembling the machine or after a
prolonged period of operation.
Adjust the throttle cable only when the
unit is completely and properly
1
assembled.
Set the throttle trigger to the full
N
throttle position.
Carefully rotate the screw in the
N
throttle trigger in the direction of the
arrow until you feel initial resistance.
Then rotate it another half turn in the
same direction.

Fitting the Carrying Ring

Polymer Version
1
For position of carrying ring see "Main
Parts".
Push the carrying ring (1) over the
N
drive tube.
Insert the M5 nut in the hex recess
N
in the carrying ring.
Fit the M5x14 screw.
N
Line up the carrying ring.
N
Tighten down the screw firmly.
N
English
15