Fitting The Harness; Balancing The Machine - Stihl FS 111 RX Notice D'emploi

Fitting the Harness

The type and style of the
harness/shoulder strap depend on the
market.
The use of the harness is described in
the chapter on "Approved Combinations
of Cutting Attachment, Deflector, Handle
and Harness".
Shoulder Strap
1
2
Put on the shoulder strap (1).
N
Adjust the length of the strap so that
N
the carabiner (2) is level with your
right hip when the machine is
attached.

Balancing the Machine

N
FS 111 RX
Balancing the Machine
Attaching Machine to Harness
The type and style of the harness or
shoulder strap and carabiner depend on
the market.
2
1
2
Attach the carabiner (1) to the
N
carrying ring (2) on the drive tube.
3
Loosen the screw (3).
N
Balancing the Machine
Adjust the carrying ring.
N
Tighten the screw moderately.
N
1
Let go of the brushcutter and check
N
to see how it is balance – the cutting
attachment should just touch the
ground in the normal working
position.
Move the carrying ring as required.
N
When the correct balanced position has
been reached:
Tighten down the screw on the
N
carrying ring firmly.
Disconnecting Machine from Harness
1
2
Press down the bar on the
N
carabiner (1) and pull the carrying
ring (2) out of the carabiner.
English
1
2
19