Operation; Checking The Battery Charge Level; Recharging The Battery - Parkside PABS 20-Li E6 Traduction Des Instructions D'origine

and cause an electric shock.
c) Do not use any accessories
that are not recommended by
PARKSIDE. This can result in electric
shock or fire.
8) RESIDUAL RISKS
Even if properly operating and handling this
electric tool, some residual risks will remain.
Due to its construction and build, this electric
tool may present the following hazards:
a) Cuts
b) Ear damage if working without ear
protection.
c) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer pe-
riods of time or if the unit is not held or
maintained properly.
Warning! During operation, this
electric tool generates an electro-
magnetic field which, under certain
circumstances, may impair the
functionality of active or passive
medical implants. To reduce the risk
of serious or lethal injuries, we rec-
ommend that persons with medical
implants consult their doctor and the
manufacturer of their medical im-
plant before operating the machine.
Observe the safety informati-
on and notes on charging and
proper use as shown in the
instruction manual for your
battery and charger from the
Parkside X 20 V Team series.
A detailed description of the
charging process and further
information can be found in
the separate operating inst-
ructions.

Operation

Remove the battery from the
device to prevent accidental
operation. Risk of injury!
Ensure that the ambient tem-
perature does not exceed
50°C or fall below -20°C
during work.
Checking the battery
charge level
The battery's (7) charge level is indicated
by the charge state indicator (8).
The LEDs indicate the battery's charge
level, when the device is in operation.
To do this, press the softkey (6) of the
charge level indicator (7).
red-yellow-green => Battery fully charged
red and yellow => Battery half charged
red
=> Battery needs

Recharging the battery

Allow a hot battery to cool before
charging.
Only charge the battery (8) when the
red LED on the charge status indicator
(7) is on.
1. Remove the battery (8) from the appli-
ance, as necessary (see „Removing/
inserting the battery").
2. Insert the battery (8) in the charging
compartment of the battery charger
(16).
GB IE
to be charged
23