Removing Tools With Hexagonal And Cylindrical Shafts; Removing The Keyless Chuck; Operation; Selecting The Operating Mode - Parkside PBHA 12 A1 Traduction Des Instructions D'origine

GB IE
4. Rotate the keyless chuck (17)
counter-clockwise, until the drill
chuck aperture is large enough to
accommodate the tool.
5. Push the tool as far as possible
into the keyless chuck (17).
6. Rotate the chuck clockwise to
clamp the tool firmly.
Removing tools with hexago-
nal and cylindrical shafts
7. To remove the tool again, rotate the
keyless chuck (1) and pull out the tool.

Removing the keyless chuck

1 Pull the locking sleeve (3) back-
wards and remove the keyless
chuck.

Operation

Selecting the operating mode

The "drilling/impact drilling" changeover
switch ( 4) allows you to select the elec-
trical tool operating mode.
Only change the operating mode
when the electrical tool is switched
on! The electrical tool may be da-
maged otherwise.
The "impact drilling" opera-
ting mode may only be used
if the keyless chuck is not at-
tached!
Unlock the changeover switch (
pushing the retaining knob (
Turn the "drilling/impact drilling" changeo-
ver switch ( 4) into the desired position.
26
The retaining knob (
into place once the final position has been
reached.

Set the direction of rotation

You can select the direction of rotation
with the direction switch (
and anticlockwise direction) and secure
the device against accidental start up.

Switching on/off

By using the on/off switch (
progressively control the speed. The longer
you push the on-off button, the higher the
speed.
4) by
5).
Impact drilling = striking mecha-
nism ON
Drilling/screwing = striking mecha-
nism OFF
1. Wait for the device to shut-down.
2. Clockwise direction:
Press direction switch (7)
to the right.
3. Anticlockwise direction:
Press direction switch (7)
to the left.
4. Switch lock: Bring direction
switch to neutral position.
The direction changed may only be
performed in standstill mode.
1. Press and hold the on/off switch
(8) to start the device. The LED
work light (11) lights up during
operation.
2. To turn it off, release the on/off
switch (8).
5) will audibly lock
7) (clockwise
8) you can