System Setup - Sherwood RD-5405 Mode D'emploi

RD-5405(G)100316_RD-5503(g) 2010-04-20 오후 7:57 페이지 27

System Setup

• The setup menu is displayed on the fluorescent display and allows you to perform the setup procedures easily. In most
situations, you will only need to set this once during the installation and layout of your home theater, and it rarely needs to be
changed later.
The setup menu consists of 5 main menus ; system, input, speaker setup, CH level and parameter. These menus
are then divided up into various sub-menus.
1.
Turn the setup menu on.
• The setup menu will be shown.
• To turn the menu off, press this button again.
2.
Select the desired menu using the CURSOR UP(▲)/
DOWN(▼) buttons.
3.
Confirm your selection.
• When selecting "SYSTEM", see "SETTING THE
SYSTEM" on page 29.
• When selecting "INPUT", see "SETTING THE INPUT" on
page 31.
• When selecting "SPK SET", see "SETTING THE
SPEAKER SETUP" on page 32.
• When selecting "CH LEVEL", see "SETTING THE CH
LEVEL" on page 36.
• When selecting "PARAMTR", see "SETTING THE
PARAMETER" on page 38.
• When selecting "EXIT", the setup menu will be turned off.
27