Sherwood RD-5405 Mode D'emploi page 35

RD-5405(G)100316_RD-5503(g) 2010-04-20 오후 7:57 페이지 35
When selecting the CROSSOVER
• When speakers are set to "S (Small)", be sure to set their crossover frequency correctly according to their frequency
characteristics.
1.
Press the CURSOR UP(▲)/DOWN(▼) buttons to
select the "X-OVER", then press the ENTER button.
2.
Press the CURSOR LEFT(◀)/RIGHT(▶) buttons to
set the crossover frequency as desired.
• You can adjust the crossover frequency within the range
of 40 ~ 200 Hz in 10 Hz intervals.
■About the crossover frequency
• When speakers are set to "S (Small)", low frequencies in
those channels that are below the crossover frequency
are to output from subwoofer or front speakers which are
set to "L (Large)" (when not using a subwoofer).
• Refer to the operating instructions of the speakers to be
connected. If the frequency range of your speaker is 100
Hz~20 kHz, the crossover frequency should be set to 100
Hz(or slightly higher).
35