Sherwood RD-5405 Mode D'emploi page 16

RD-5405(G)100316_RD-5503(g) 2010-04-20 오후 7:57 페이지 16
When adjusting the sound parameters
• While playing digital signals from Dolby Digital or DTS program source or listening in Dolby Pro Logic II Music mode, you
can adjust their parameters for optimum surround effect.
1.
Press the SOUND PARAMETER button.
• Then "NIGHT : ~ " (or "PANO : ~ ") is displayed for several
seconds.
• If the parameter mode disappears, press this button again.
2.
Press the CURSOR UP(▲)/DOWN(▼) buttons to
select the desired parameter.
• Each time these buttons are pressed, the parameter mode
changes as follows:
→ "NIGHT" ↔ "PANO" ↔ "C.WIDTH" ↔ "DIMEN" ←
(Night mode) (Panorama mode)
• "NIGHT" can be selected only while playing digital signals
from Dolby Digital or DTS source.
• "PANO", "C.WIDTH" and "DIMEN" can be selected only
while listening in Dolby Pro Logic II Music mode.
(Center width control) (Dimension control)
3.
Press the CURSOR LEFT(◀)/ RIGHT(▶) buttons to
adjust the selected parameter as desired.
■When selecting the "NIGHT (Night mode)"
This function compresses the dynamic range of previously
specified parts of Dolby Digital or DTS sound track (with
extremely high volume) to minimize the difference in
volume between the specified and non-specified parts. This
makes it easy to hear all of the sound track when watching
movies at night at low levels. The night mode can be set in
11 steps from 0.0 to 1.0 (default value : 0.0).
■Note : In some Dolby Digital or DTS softwares, the night
mode may not be valid.
■When selecting the "PANO (Panorama)" mode
This mode extends the front stereo image to include the
surround speakers for an exciting "wraparound" effect with
side wall imaging.
Select "OFF" or "ON"(default value: OFF).
■When selecting the "C. WIDTH (Center width)"
control
This adjusts the center image so it may be heard only from
the center speaker, only from the left/right speakers as a
phantom image, or from all three front speakers to varying
degrees.
The control can be set in 8 steps from 0 to 7(default value :
3).
■When selecting the "DIMEN (Dimension)" control
This gradually adjusts the soundfield either towards the
front or towards the rear. The control can be set in 7 steps
from -3 to +3 (default value : 0).
4.
Repeat the above steps 2 and 3 to adjust other
parameters.
16