Sherwood RD-5405 Mode D'emploi page 34

RD-5405(G)100316_RD-5503(g) 2010-04-20 오후 7:57 페이지 34
When selecting the DISTANCE
1.
Press the CURSOR UP(▲)/DOWN(▼) buttons to
select the DISTANCE, then press the ENTER button.
2.
Press the CURSOR UP(▲)/DOWN(▼) buttons to
select the desired item.
■Note :
• You cannot select the speakers set to "N (None or No)".
3.
Press the CURSOR LEFT(◀)/RIGHT(▶) buttons to
set the selected item as desired.
■When selecting the desired unit
• You can select either "M (Meter)" or "FT (Feet)".
• Once a unit is selected, the distances are automatically
changed in the selected unit.
■When setting the distance
• You can set the distance within the range of 0.0 ~ 9.0
meters in 0.3 meter intervals(or 0 ~ 30 feet in 1 feet
intervals).
4.
Repeat the above steps 2 and 3 until the distances are
all set as desired.
■About the speaker distance
When enjoying multi-channel surround playback with Dolby
Digital sources, etc., it is ideal that the center, surround and
subwoofer speakers should be the same distance from the
main listening position as the front speakers. By entering
the distance between the listening position and each
speaker, the delay times of center, surround and subwoofer
speakers are automatically adjusted to create an ideal
listening environment virtually as if the center, surround and
subwoofer speakers were at their ideal locations
respectively.
34