Enjoying Surround Sound - Sherwood RD-5405 Mode D'emploi

RD-5405(G)100316_RD-5503(g) 2010-04-20 오후 7:57 페이지 15

ENJOYING SURROUND SOUND

■Notes:
• Before surround playback, first perform the speaker setup procedure, etc. on the SETUP menu for optimum performance.
(For details, refer to "SETTING THE SPEAKER SETUP" on page 32.)
• Even when the auto surround mode is selected and the same type of digital signal format is being input, the optimum
surround mode may vary depending on whether the speaker type is set to "N (None)" or not.
• When 96 kHz PCM digital signal is being input, only the stereo mode will be selected .
■Select the desired surround mode
Signal format being input
Dolby Digital 5.1 channel sources
Dolby Digital 2 channel sources
DTS sources
PCM (2channel) sources,
Analog stereo sources
• Depending on speaker setting, some surround modes can be selected or not as follows :
[ ] : Possible only when "CENTER" or/and "SURR (Surround)" is/are not set to "N (None)".
< > : Possible only when "CENTER" and "SURR (Surround)" are set to "N (None)".
■To cancel the surround mode for stereo operation
■2CH downmix mode
• This mode allows the multi-channel signals encoded in Dolby Digital or DTS format to be mixed down into 2 front
channels and to be reproduced through only two front speakers.
• Each time the SURROUND MODE UP/DOWN (▶, > /
Selectable surround mode
[DOLBY DIGITAL, AUTO SURROUND] or <DOLBY DIGITAL>
[DOLBY PLII MOVIE, DOLBY PLII MUSIC, DOLBY PRO LOGIC, AUTO SURROUND] or
<DOLBY DIGITAL>
[DTS, AUTO SURROUND] or <DTS>
[DOLBY PLII MOVIE, DOLBY PLII MUSIC, DOLBY PRO LOGIC, MATRIX, CHURCH, THEATER,
HALL, STADIUM, AUTO SURROUND] or <STEREO>
• Depending on the signal format which is being input, either
the stereo mode or the 2CH downmix mode is selected.
• To cancel either the stereo mode or the 2CH downmix
mode, select the surround mode with using the
SURROUND MODE UP/DOWN (▶, > / ◀, <) buttons.
15
◀, <) buttons are pressed, the surround mode changes
as follows :
Manual surround mode : You can select the desired of
("AUTO" indicator goes off.)
different surround modes
selectable for the signal being
input.
Auto surround mode : The optimum surround mode will
be automatically selected
("AUTO" indicator lights up.)
depending on the signal format
being input.