Connecting Speakers - Sherwood RD-5405 Mode D'emploi

RD-5405(G)100316_RD-5503(g) 2010-04-28 오전 9:52 페이지 6
4.
CONNECTING SUBWOOFER PRE OUT
• To emphasize the deep bass sounds, connect a powered
subwoofer.
5.

CONNECTING SPEAKERS

• Be sure to connect speakers firmly and correctly according to
the channel(left and right) and the polarity(+ and -). If the
connections are faulty, no sound will be heard from the
speakers, and if the polarity of the speaker connection is
incorrect, the sound will be unnatural and lack bass.
• For installing the speakers, refer to "Speaker placement" on
page 7.
• After installing the speakers, first adjust the speaker settings
according to your environment and speaker layout.
(For details, refer to "SETTING THE SPEAKER SETUP" on
page 32.)
Caution :
• Be sure to use the speakers with the impedance of 6 ohms or
above.
• Do not let the bare speaker wires touch each other or any
metal part of this unit. This could damage this unit and/or the
speakers.
• Never touch the speaker terminals while the AC input
cord is connected to the wall AC outlet. Doing so could
result in electric shocks.
■Connecting speaker wire
1. Strip away approx. 10 mm
(3/8 inch) of wire insulation,
then twist the wire ends
tight.
6.
AC INPUT CORD
• Plug the cord into a wall AC outlet.
2. Lossen by turning the
speaker terminal counter-
clockwise.
6
3. Insert the bare part of the
wire.
4. Tighten by turning it
clockwise.