Adjusting The Tone (Bass And Treble) - Sherwood RD-5405 Mode D'emploi

RD-5405(G)100316_RD-5503(g) 2010-04-20 오후 7:57 페이지 13

Adjusting the tone (bass and treble)

7.
Enter the tone mode.
• The tone mode is displayed for several seconds.
8.
Press the CURSOR LEFT(◀)/RIGHT(▶) buttons to
select the desired tone mode.
• Each time these buttons are pressed, the tone mode is
selected as follows :
OFF : To listen to a program source without the tone effect.
↕
("DIRECT" indicator lights up.)
ON : To adjust the tone for your taste.
("DIRECT" indicator goes off.)
■When the TONE is set to ON to adjust the tone
(bass and treble).
9.
Press the CURSOR UP(▲)/DOWN(▼) buttons to
select the desired tone.
• Each time these buttons are pressed, the tone is selected
as follows :
→ BASS ↔ TRBL (treble) ↔ TONE: ON ←
10.
Press the CURSOR LEFT(◀)/RIGHT(▶) buttons to
adjust the selected tone as desired.
• The tone level can be adjusted within the range of -10 ~
+10 dB.
• In general, we recommend the bass and treble to be
adjusted to 0 dB (flat level).
• Extreme settings at high volume may damage your
speakers.
• To complete tone adjustment, repeat the above steps 9
and 10.
• If the tone display disappears, start from the step 7 again.
13