Characteristics, Protective Functions - Multiplex ROXXY BL-Control OPTO 900 Série Notice D'utilisation

Parameter type
Parameter 1 Battery type
Parameter 2 Direction of motor rotation
Parameter 3 - Brake ON/OFF (AIR)
- Brake ON/OFF (HELI)
- Reverse ON/OFF (CAR, BOAT)
Parameter 4 Model type AIR/HELI
Parameter 5 Model type BOAT/CAR
To change the Parameters, the throttle stick must be moved
quickly from full throttle to the stop position and held for a
minimum of 3 seconds in the stop position.
Parameter type
Battery type
Direction of rotation
Brake (AIR)
Governor (HELI)
Reverse (CAR, BOAT)
Model type (AIR/HELI)
Model type (BOAT/CAR)
Moving the throttle stick quickly from stop to forward position
stories the changes.

5.1. Characteristics, protective functions

POR Start protection, stops involuntary starting of the motor.
Low voltage cut-off, the motor will be stopped before the voltages reaches a level where control is lost and
PCO
potential deep discharge damage to the cells can occur.
SPS Super Programming System
Cool Power FET Latest generation power transistor.
Galvanic separation of the motor interference and receiver.
Opto
RX-Filter Switches the controller OFF when a transmitter signal is not present or corrupted.
TP Thermal Protection
Hec High motor frequency
www.modellmarkt24.ch www.modellmarkt24.ch
To set the parameters, move the throttle stick from the stop
position to full throttle and back.
LED ON
Beep every 2 Sec.
LiPo
Normal
OFF
OFF
OFF
AIR
BOAT
Completing and storing the programmed settings is made by
momentarily removing the power supply battery. The controller
is now programmed and ready for operation.
Beep LED
1 x 1 x
2 x 2 x
3 x 3 x
4 x 4 x
5 x 5 x
LED l ashes
Beep every 0,5 Sec.
NiCD/NiMH
Reverse
ON
ON
ON
HELI
CAR
13