Programming The Stick Positions; Programming The Speed Controller Parameters Without Using The Programmer - Multiplex ROXXY BL-Control OPTO 900 Série Notice D'utilisation

4. Programming the stick positions

The model type must be chosen (Parameter 4 or
!
Parameter 5). Otherwise the new parameters will not
be stored.
Forward, stop and reverse
1. Connect the controller according to the above photograph (with the exception of the power battery).
2. Turn on the Tx and move the throttle stick fully forward.
3. Connect Power Battery to the controller.
If after (step 3) the red LED illuminates, then the SERVOREVERSE function must be operated in the Tx, remove power supply,
!
reconnect and restart the programming (step 1). The fully forward position of the stick must be set near the mechanical
stick limit.
4. The controller will confirm connection with a short beep.
5. After approximately 10 seconds you will hear a double beep as confirmation of the fully forward position.
6. Move throttle stick to closed position, a short beep will confirm.
7. Finally move the throttle stick to the reverse position; a
triple beep confirms the programming of the reverse
position.
5. Programming the speed controller parameters without
using the Programmer
Five parameters may be programmed in this manner.
Entry into programming mode is made by:
1. Controller connected as per the above photograph
(except the Power Battery).
2. Turn Tx on and move throttle stick to forward position.
3. Connect Rx battery supply.
4. Controller will beep to confirm.
5. After approximately 10 seconds, you will hear a double
beep and after a further 3 seconds, a triple beep will be
heard.
12
www.modellmarkt24.ch www.modellmarkt24.ch
Forward and stop (Model type Air/Heli)
Programming the forwards and stop stick positions
of the controller should only be used in forwards op-
!
eration (no reverse!); this is made in a same manner
up to step 3.1.6. The programmed stick positions are
coni rmed with a triple beep.
Parameter 1 has been chosen when the controller continuously
emits single beeps and the LED l ashes.
The following stick movements set the program Parameters:
Move the throttle stick to closed position and quickly return
to full throttle. The controller will indicate the effective pro-
gramming of Parameter 2 by a continuing double beep and
l ash of the LED.
For programming Parameters 3, 4 and 5 the sequence de-
scribed above must be followed.