Lubrication; Replacing The Cutting Blade - GreenWorks Tools GD40LM46 Manuel D'utilisation

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
To reduce the risk of damage and danger, never
clean the tool with pressure washer or under running
water.
Store indoors only. Always remove the battery from
mower and charger when cleaning or storing the tool.
Do not at any time let brake fluids, gasoline,
petroleum-based products, penetrating oils, etc.,
come in contact with plastic parts. Chemicals can
damage, weaken, or destroy plastic which may result
in serious personal injury.
Periodically check all nuts and bolts for proper tightness
to ensure safe operation of the mower.
Wipe the mower clean with a dry cloth occasionally. Do
not use water.

LUBRICATION

All of the bearings in this product are lubricated with a
sufficient amount of high grade lubricant for the life of
the unit under normal operating conditions. Therefore,
no further bearing lubrication is required.
Always protect hands by wearing heavy gloves
and/or wrapping the cutting edges of the blade with
rags and other material when performing blade
maintenance. Contact with the blade could result in
serious personal injury.
Do not lubricate any of the wheel components.
Lubrication may cause the wheel components to fail
during use, which could result in serious personal
injury to the operator and/or mower or property
damage.

REPLACING THE CUTTING BLADE

See figure 11-12.
NOTE: Only use authorised replacement blades.
Replace worn or damaged blades and bolts in sets to
preserve balance.
■ Stop the motor and remove the battery key. Allow
blade to come to a complete stop.
■ Remove the battery pack.
English (Original Instructions)
WARNING
WARNING
WARNING
WARNING
WARNING
■ Turn the mower on its side.
■ Wedge a block of wood between the blade and
mower deck to prevent the blade from turning.
■ Loosen the blade bolt by turning it counterclockwise
(as viewed from bottom of mower) using a 27 mm
wrench or socket (not provided).
■ Remove the blade bolt and blade.
■ Place the new blade on the shaft. Ensure blade
is properly seated with shaft going through center
blade hole and the two blade posts on the fan
inserted into their respective holes on the blade.
Make sure it is installed with the curved ends
pointing up toward the mower deck and not down
toward the ground. When seated properly, the
blade should be flat against the fan.
■ Thread the blade bolt on the shaft and finger tighten.
■ Torque the blade bolt down clockwise using a
torque wrench (not provided) to ensure the bolt is
properly tightened. The recommended torque for
the blade bolt is 62.5~71.5 kgfcm (350-400 in.-lb.).
5