HumanTechnik Signolux S Mode D'emploi page 14

Troubleshooting and solutions
Symptoms
When trying to program a
transmitter, a different icon
lights up...
The red status LED light up
with an alert...
The »signolux« receiver
does not work...
There is no alert tone...
The flash light does not
work...
14 English
Cause
The transmitter you are
trying to program is already
known by the receiver.
This indicates a low battery
in the according transmit-
ter.
Ensure that the
rechargeable batteries
have been inserted
correctly.
Check if the batteries are
charged
Maybe the triggered trans-
mitter has not yet been
paired with the »signolux«
receiver.
Perhaps the »signolux«
receiver is out of reach of
the transmitter.
mode selector switch is on
position 2 (fig. 2)
mode selector switch is on
position 0 (fig. 2)
Solutions
See step 7. Delete the trans-
mitter from the receiver's
emory before it can be as-
signed to a new icon.
Insert a new battery in the
transmitter.
Ensure correct polarity of the
rechargeable batteries!
Connect the receiver to the
power supply.
Assign it to an icon.
Try using the transmitter or
receiver at different location.
Check the position of
the switch (fig. 2) on the
»signolux« receiver.
Ensure that the volume is not
set to the lowest setting.
Check the position of
the switch (fig. 2) on the
»signolux« receiver.