HumanTechnik Signolux S Mode D'emploi page 12

5. Programming signals and assignment
to the event icons
Up to 8 transmitters can be assigned to each
event icon. This assignment can be adapted
by programming. Kindly keep in mind that a
transmitter can only be programmed if it is
not yet known in the memory of the »si-
gnolux« receiver. If required, you first might
have to delete the transmitter from the memory
(see step 7).
a) Keep the function button »●« (fig. 2)
pressed for some time. The event icons
start to light up in sequence. Let go of the
key as soon as you see the desired icon.
b) Trigger your transmitter (e.g. operate the
doorbell pushbutton or test button).
c) Wait for about 20 seconds and test the
function.
6. Setting the melody
You can adapt the melody for each icon:
a) First trigger an alert (e.g. operate door-
bell pushbutton).
b) The icon assigned to the transmitter
should light up and the previously cho-
sen tone should be heard.
c) Press and hold the melody setting but-
ton »♫« (fig. 2) for two seconds.
Let go of the button and press it repeat-
edly until you have found the desired
melody (you can choose from 15 different
tones).
d) Once the icon ceases to flash, the
selected tone has been assigned.
12 English
7. Deleting transmitters from receiver
memory
Do the following if you want to delete a
transmitter from the memory:
a) Keep the function button »●« (fig. 2)
pressed for some time. The event icons
light up in sequence. Let go of the key as
soon as you see the desired icon.
b) Now press the function button »●« and
the melody button »♫« (fig. 2) at the
same time, until all icons briefly light up.
Please note that this will remove all assigned
transmitters from the selected event icon.
8. Battery level indication
The receiver informs about the state of the
batteries of the receiver as well as the batte-
ries of the transmitters:
- A sufficient battery charge level of the
receiver is indicated by the red status
LED flashing every 5 to 6 seconds.
- A low battery level of the receiver is in-
dicated by the red status LED flashing in
short sequence (once per second).
Please recharge the receiver batteries as
soon as possible (attach it to the power sup-
ply unit).
- A low battery level of a transmitter is indi-
cated by the staus LED blinking
together with the icon of the according
transmitter when its signal is triggered.
Please replace the batteries of the accor-
ding transmitter as soon as possible.