Solo 532 Instructions D'emploi page 9

•
If the machine is left unattended, ensure that it cannot start up again.
•
Before running the machine, the operator must have a 5 meter radius of free space around him.
•
Dry any petrol leaks.
•
Fill up the tank with the motor off. Filling the tank or transferring fuel must always be performed outdoors, away from flames
or heat sources. Do not smoke during this operation.
•
When mowing in mountainous areas or on slopes, mow horizontally and use non-skid equipment on shoes and wheels.
•
If the blade needs replacement, observe E.S.M. operation and maintenance procedures.
•
If the bar suffers impact, check the condition of the bar before resuming work.
•
Keep feet and hands far away from the cutting bar and all rotating parts.
•
Do not run the motor where exhaust containing carbon monoxide may accumulate.
•
Never use the mower incomplete or without its safety device.
•
Do not assemble/disassemble or clean the cutting bar or other equipment with the motor running.
•
Caution! Do not mow areas with slopes exceeding 50%.
•
We will not be held liable for accidents caused by the failure to observe these rules.
Every time you get ready to start the motor, make a
careful check of the following:
•
Make sure that fuel is in the tank.
•
Check engine oil level. IMPORTANT: ENGINES OF
NEWLY MANUFACTURED MACHINES DO NOT
CONTAIN OIL. In this case, fill with oil up to the oil
plug stick.
•
CONSULT THE OPERATION AND MAINTENANCE
MANUAL OF THE MOTOR UNDER "BEFORE
START-UP"
•
Make sure oil is up to the level in the gearbox (Pict.
12 Ref. B)
•
Check that all safety systems are released and
functioning.
•
Before starting the machine, when the engine is cold, pull the choke, if it is fitted on your machine.
•
Always start the motor up outdoors.
•
For versions FC 209 and 210 H 3VS, lower the starter lever (when starting a cold engine), for version FC 200 D 3VS, turn
the lever of the air pump, located above the cylinder head.
•
For versions FC 209 and 210 H 3VS, turn the accelerator lever (Pict. 6A Ref. "F") to "START" position, for the FC 200 D
3VS version, turn the lever by a ¾ turn (Pict. 6B Ref. "F") . Pull the clutch lever (Pict. 8 Ref. "A"), lower the engine stop lever
(Ref. "C") and lock it with the push-button (Pict. 8 Ref. "B"). Grip the handle of the self-winding device (Pict. 7), pull gently
until you meet resistance, and then pull it firmly. Do not allow the cord to return to its position on its own, but accompany it
with your hand.
•
For best start-up, read the operation and maintenance manual on the motor under "START-UP".
•
After starting the engine, disengage the starter lever.
•
With the motor running, bring the accelerator lever (Pict. 6A-B Ref. "F") to the middle position.
•
To move the mower forward, grip the clutch lever (Pict. 8 Ref. "A") , select the speed your require with the gear-stick (Pict. 4
Ref. "A"), slowly lower the clutch lever (Ref. "A"), releasing it from the push-button (Pict. 8 Ref. "B"). To engage the mowing
bar, lower the lever (Pict. 8 Ref. "D") taking care to always do this while the engine is idling. After engaging the bar, you may
accelerate.
•
To move the mower freely forward or back, lift up the wheel release lever (Pict. 8 Ref. "E").
9