Accessories; Special Accessories; Operation; Switching On Automatically - Gaggenau CG 280 Mode D'emploi

Accessories

As standard, your appliance comes with the following
accessories:
Wok ring (647660)
▯
For using a wok pan on the wok burner.

Special accessories

You can order the following special accessories from
our after-sales service or on our website:
Wok pan (WP 400 001)
▯
Multi-layer material wok pan, with curved base
and handle, Ø 36 cm, 6 liters volume,10 cm high.
Coffee maker support (088903)
▯
Only use the coffee maker support on the
economy burner with cooking vessels no more
than 9 cm in diameter (e.g. coffee maker).
Simmering plate (648786)
▯
Only use the simmering plate on the economy
burner. This accessory has been designed to
reduce the heat at the lowest power setting (low
heat).
Place the simmering plate on the pan support
with the cones facing upwards, never directly on
the burner. Centre the pan over the simmering
plate.
Only use the accessories as specified. The
manufacturer accepts no liability if these accessories
are used incorrectly.

Operation

The markings on the control knobs show the position
of the corresponding burner and the setting between
high and low heat. The flame setting is infinitely
variable between high and low heat.
Notes
‒ Only light a burner if all pan supports and burner
parts are properly assembled.
‒ Make sure the burners and ignition sparkers are
clean and dry.
‒ Only use the recommended accessories. Do not
cover the stainless steel cooktop base (e.g. with
aluminium foil).

Switching on automatically

Your cooktop features ignition sparkers for automatic
ignition.
1
Place a suitable pot or pan on the corresponding
cooking position.
2
Fully press down the corresponding control knob
and turn it anticlockwise to the required position.
The burner lights automatically.
3
Keep the control knob pressed for a few seconds
after ignition.
The flame size can be set continuously between high
and low by slowly turning the control knob.

Switching on manually

During a power cut you can ignite the burners
manually.
1
Place a suitable pot or pan on the chosen burner.
2
Press the corresponding control knob and turn it
anticlockwise to the required setting. Keep the
control knob pressed.
3
Use a gas lighter or a match to ignite the burner.
Keep the control knob pressed for a few seconds
after ignition.

Switching off

Turn the corresponding control knob clockwise to the
OFF position.

Thermoelectric flame monitoring

For your safety, this cooktop features thermoelectric
flame monitoring. This prevents gas escaping, if a
burner accidentally goes off during use (for example
from a draught).
Should a burner accidentally go off during use, turn
the control knob to the OFF position and wait at least
30 seconds before re-igniting the burner.
15