Figure - Megger OTS 60AF/2 Guide D'utilisation

Language Select
The display screen and print-out can be set to read in any one of six languages:-
Scroll through and select as before. Pressing SELECT returns to the sub-menu.
Note:- A quick way to bring the language screen into view on the screen is to press and hold the right
hand key while switching the test set on. After making the selection proceed through the
remainder of the OPTIONS sub-menu.
Setting the printer options
Scroll through the OPTIONS sub-menu to PRINTER CONTROL and press SELECT.
A further sub-menu is displayed as follows:
Where applicable, the status of each option is given (e.g. NO. OF COPIES 1), and this can be altered as
required by successive pressing of the SELECT key. For example, to change the 'On'/'Off' mode of the
internal printer, scroll through this sub-menu to INT PRINTER, and press SELECT. It is expected that the
internal printer will normally be on.
Note:- Successive pressing of the SELECT key toggles the internal printer between the 'On' and 'Off'
mode. This automatically switches the EXT PRINTER (external printer option) to the opposite
mode. It is not possible to use both the internal printer and an external printer together.
If an external printer is to be used, the Baud rate of the the test set must be adjusted to match that of the
printer. To do this, scroll through the menu until BAUD RATE is highlighted. Successive pressing of the
SELECT key will scroll between standard Baud rates available i.e. 9600, 4800, 2400, 1200, 600, 300 and
150. Leave in view the one to be chosen. The data transfer format is:-
One or two copies of the results print-out may be made. Scroll through to No. OF COPIES and press
SELECT to toggle between the selection of 1 or 2. Leave the required number displayed. The PRINT
LAST RESULTS option causes the last set of test results to be printed when the SELECT key is pressed.
Note:- The last set of test results remain in the internal memory when the instrument is switched off or
the test chamber cover interlock switch is opened. The test set will automatically print the results
of a test when completed if the AUTO PRINT option is set to 'On'. Scroll through as before until
the option is highlighted and, if necessary, press SELECT until the required status is displayed.
If this option is set to 'Off' then a PRINT option will be given at the end of a test sequence.
To move back into the OPTIONS sub-menu scroll through until QUIT is highlighted, then press SELECT.
To move back to the main menu from the OPTIONS sub-menu scroll through until MENU is highlighted
and press SELECT.
TIME / DATE
The correct time and date are pre-set and will not normally need to be adjusted. The internal 24 hour
clock is powered by a LITHIUM battery with a life of 10 years.
ENGLISH
FRANCAIS
DEUTSCH
ESPANOL
PORTUGUES
ITALIANO
PRINT LAST RESULTS
AUTO PRINT
NO. OF COPIES
BAUD RATE
QUIT
INT. PRINTER ON
EXT. PRINTER OFF
1 start bit
8 data bits
1 stop bit
no parity
13