Initial Operation - PIKO VT Manuel D'utilisation

- Authentic color scheme
- Authentic and comprehensive
lettering and decoration
Getting Started: Initial Operation
Unpacking the Model
Remove the styrofoam packaging
extremely carefully to prevent
damaging accessories and attached
parts.

Initial Operation

We recommend letting the model run
for 30 minutes in both directions, to
properly break it in. This will help
achieve optimal performance and
longevity. Of course, your model
should only be run on smooth and
perfectly clean tracks with reliable
electrical contact to all track sections.
Technical Data
Power Supply
The model should only be operated on
a pure, filtered DC power supply of 0
to 24 volts, with a capacity of at least
2 Amps and a fast-acting fuse or
circuit breaker to protect against short
circuits. Do not use a power supply
which is not in safe and perfect
working condition.
Drive System
The locomotive contains a robust
gearbox with a powerful high-
precision can-type motor driving both
axles through a smooth gear drive.
Lighting
Triple LED-lighted lanterns on each
end change according to the direction
of travel.
Radius
The locomotive can run on a track
with a minimum recommended radius
of 600 mm (23.62'').
Accessories
Digital Decoder
The model is prepared for "plug and
play" installation of a PIKO #36122
Loco Decoder (available separately).
As soon as the decoder is properly
installed, the model can be operated
on digital as well as Analog DC-
powered layouts.
Sound Module
The model is prepared for "plug and
play" installation of a PIKO #36192
Sound Unit (available separately). This
sound unit reproduces authentic
sounds of the real engine. The sound
unit requires that the locomotive be
equipped with a PIKO #36122 loco
decoder. The sound unit must be
connected to the loco decoder via the
included interface cable. The sound
unit includes a high-quality extended
frequency range speaker with a
waterproof diaphragm for outdoor
operation. Note: The sound unit is
operable only on digital layouts, not
on Analog DC-powered layouts.
Maintenance
Lubrication
After each 25 hours of operation, and
after any long periods of storage, please
lubricate the locomotive's gears with a
sparing amount of plastic-compatible,
non-hardening grease. Remove the
gearbox bottom cover and be careful to
keep the front and rear wheelsets aligned
with each other. Be sure to securely re-
tighten the gearbox bottom cover screws.
Cleaning
If cleaning is necessary, use only a mild
cleaning agent (such as soap and water)
and gentle action with a soft non-abrasive
cloth or brush. Never immerse the loco in
liquid or "flood" any internal parts!
Wheel Wipers and pick-Up shoes should
be changed after 500 hours of operation.
Please Note! Damage to Carpets and
Other Surfaces: Normal operation of the
locomotive causes wear of mechanical
parts (wheels, electrical pickups etc.).
This produces carbonized dust, grease
and oil, which can permanently stain
carpets, wood floors and other
materials. It is the user's responsibility
to take proper precautions against this
damage. Wipe any grease or oil from
the track rails with a clean soft cloth.
PIKO Spielwaren GmbH, as well as its
representatives, distributors and
retailers, assume no liability for any
such damage.
Please Note!
Important Safety Precautions
• Check the power supply regularly for any
damage or problems.
• Do not use a malfunctioning or damaged
power supply!
• This model must only be operated with
one power source per circuit!
• This product is not a toy, not suitable for
personnel under 14 years of age. This
product has small parts, sharp parts, and
moving parts.
• This model must only be operated with a
safety-assured power supply with the
identification!
• The power supply is not a toy!
• Disconnect the model from the power
supply before cleaning or servicing!
• Do not insert the track power connecting
wires into household "mains" voltage
outlets.
5